WLAN Bridgelink Bundle
Bridging of radio links in outdoor environments
The WLAN Bridgelink Bundle is designed for establishing outdoor wireless links. The bundle includes two W1002n (802.11n) access points and all the necessary components.
WLAN Bridgelink Bundle 'Out-of-the-Box'
The bundle contains all required components to setup a radio link by using the new 802.11n technology. The usage of the components makes sense for radio links with up to 6 km distance.
The following components are contained:
In case of free line of sight the following results are expected by using the following configuration:
Hints to improve the operating distance:
- Use shorter cables, to reduce the cable loss
- Use a antenna with higher gain
- Select 20 MHz bandwidth instead 40 MHz, or use only one stream.
Hints for installation:
- The link must be free from any obstacles (free line of sight). If necessary a different location must be used or the antenna height must be increased.
- The antenna connectors of the Access Point ANT1 and ANT2 are connected to the antenna. It makes no difference which antenna socket is used. The antenna connector ANT3 of the AP are not used for these application.
- The antenna or rather the antenna pole must be connected with 16 mm2 CU or more to the potential equalisation. The Surge Arrestor protect the AP and must connected to the grounding of the building with 1,5 mm2 CU or more. The Surge Arrestor must be inserted in both antenna cables, usually close to the place there the antenna cable leaving the building. In some cases it is advisable to consult a specialist for lighting protection.
Variants
WLAN-Bridgelink-Bundle (5510000226)
included: 2 x bintec W1002n (5510000165); 4 x 0,5m RTNC plug N plug LMR400 (600507); 4 x Surge Arrester N plug N jack (600499); 4 x 6m N plug N jack LMR400 (5500000847); 2 x ANT-N-20-5G Dual Polarization (5500000551)
Options
At the moment there are no entries available.
Antenna
Deutsch
Italian
French
High Quality
Low Quality